Aeroseal Partner London
Aeroseal is a breakthrough HVAC duct sealing technology developed in 1993 by Dr. Mark Modera in his garage. For the first time ever it was possible to seal leaks in ducts from the inside out.
The problem is most ducts in commercial buildings leak air and this was chalked up as a common problem one that was just accepted. Case studies have shown sealing ducts reduces energy waste by eliminating the cracks & holes.
ROI Calculator
Return on investment
When it comes to saving money there is potentially an investment. To
assist with the financial return, we have provided a rough guide
based on an average project. The cost of Aeroseal may vary
depending on the type of project, ie, ceiling heights to block vents,
duct length and daytime access.
Also, we can provide an independent pressure test which provides a
detailed report providing the information required to assess the ROI.
Please contact us to discuss the options as we are keen to give you
the service you require and advise on saving money and ultimatly
reduce carbon output.
What is Aeroseal?
AEROSEAL is the patented technology for efficiently & effectively sealing existing air duct systems from inside out in the swiftest possible way and with little disturbance.
Ductwork leakage rates are shown outlined in BESA DW144 and systems should be manufactured and fitted to comply with this specification.
Now the integral component is in the installation of new ventilation systems. Maximum air tension requirements for duct work can be guaranteed as well as achieved.
The revolutionary and patented AEROSEAL process was developed in the 1990s at the University of Berkeley - California. This technology is now successfully installed in more than 125,000 air duct systems, in residential and commercial buildings, all over the world.
Since its European launch in 2015 AEROSEAL has set new standards for the tightness of air duct systems.
How Does Aeroseal Work?
Aeroseal works by injecting a water soluble sealant aerosol into the ductwork system using heated compressed air, the aerosol is then transported to the points of leakage from the inside and attaches itself to the side of the hole and over a period of approx. 30mins slowly reduces the hole in size.
The Benefits of Aeroseal
Reduces leakage in average 95%
•Improved pressure conditions in the duct system and indoor air quality (IAQ)
•Holds pressure up to 2.000 Pa
•Reliably seals gaps up to 15mm
•Works on sheet metal, concrete, stone, plastic, silicium, promat…
•Fullfills all relevant requirements in terms of hygiene, fire protection, VOC etc.
•If dust on surface < 3mm no cleaning before process necessary
•Needs only 1-2 person to operate the process
•Its possible to seal up to 5 air ducts a day (approx. 1.000 to 2.500m²)
•2 hours after sealing system can be used again
•Energy savings up to 50% after application
•Return on investment 1-5 years
